klungly
Member
Presses on the axle seal, set the pinion preload and pinion nut torque. Welded on the hydraulic ram clamp feet. This axle is almost done, I think...
I used an old bearing out race to press in the new seal. I was getting frustrated trying to tap it in with a hammer. It worked amazingly well.![20171225_234513.jpg 20171225_234513.jpg](https://www.wayalife.com/data/attachments/242/242528-e72dc8bc455a4f3be41fe1a8b6a0ff40.jpg)
![20171225_232701.jpg 20171225_232701.jpg](https://www.wayalife.com/data/attachments/242/242539-a1f68c561b00e002ce092d5ff8cb20f9.jpg)
Sent from my SM-G950U using WAYALIFE mobile app
![20171225_232709.jpg 20171225_232709.jpg](https://www.wayalife.com/data/attachments/242/242506-f7cde4f49240e29477209b66a2d88f5d.jpg)
![20171225_234513.jpg 20171225_234513.jpg](https://www.wayalife.com/data/attachments/242/242528-e72dc8bc455a4f3be41fe1a8b6a0ff40.jpg)
![20171225_232701.jpg 20171225_232701.jpg](https://www.wayalife.com/data/attachments/242/242539-a1f68c561b00e002ce092d5ff8cb20f9.jpg)
Sent from my SM-G950U using WAYALIFE mobile app