What was done to your rig this week?

No...but I should have! I ended up using an Air wrench on the driver side and a regular wrench on the passenger side. Both sides however required a breaking bar to get loose. Those two bolts were the most difficult.

Gotcha. Think I might go and make the purchase of the gear wrenches and just put them in my tool bag. Been wanting them anyways.
 
I got my Mopar half doors back from paint and put together last night! Took about 4 hours to assemble them and another hour to mount and adjust.
They look too new!

h14rIVRl.jpg
Gbl6U72l.jpg
 
ImageUploadedByWAYALIFE1436582284.339923.jpg
ImageUploadedByWAYALIFE1436582297.444786.jpg

Got the LoD sliders used from a member. Got them installed now time to get some more rust off and paint these!!

Loving these so much more than my poison spider boat sides and I haven't even used them yet!
 
Got the LoD sliders used from a member. Got them installed now time to get some more rust off and paint these!!

Loving these so much more than my poison spider boat sides and I haven't even used them yet!

If you don't mind me asking why'd you switch to the LõD over the PS?
 
If you don't mind me asking why'd you switch to the LõD over the PS?

The poison spyder one never fit really snug against the body and there was a gap. Water and dirt would collect.

Plus all the dirt that would get stuck inside the slider sucked.

I wanted frame mounted sliders too, with a nice step, so these are perfect for what I always wanted! 👍

Next, we got to get some 37's underneath our rigs!!
 
ImageUploadedByWAYALIFE1436652818.003053.jpg

Painted and installed!

They're still a little wet, but I couldn't watch paint dry any longer 😴 I'll have to touch up underneath.
 
The poison spyder one never fit really snug against the body and there was a gap. Water and dirt would collect.

Plus all the dirt that would get stuck inside the slider sucked.

I wanted frame mounted sliders too, with a nice step, so these are perfect for what I always wanted! 👍

Next, we got to get some 37's underneath our rigs!!

Ah ok yea that dirt n water would probably cause problems later on

View attachment 153225

Painted and installed!

They're still a little wet, but I couldn't watch paint dry any longer 😴 I'll have to touch up underneath.

Looks good!
 
PSC BFH trail stinger, switch-pros, lockers front and rear, ARB compressor.
 

Attachments

  • 1436658256943.jpg
    1436658256943.jpg
    69 KB · Views: 314
  • 1436658276822.jpg
    1436658276822.jpg
    131.5 KB · Views: 319
ImageUploadedByWAYALIFE1436668451.884183.jpg
Louisiana water is actually full of sand! Pulling shafts to install sleeves, locker, gears, and discovered this pretty little mess. Tubes are full of sand, amazed the seal was good and diff wasn't filled
 
Top Bottom