3D Printing

OverlanderJK said:
I really just think that bottom piece needs to be wider. Not even sure now that I look at it it needs to be printed. That piece is like a rubber piece that’s bent. The dust collection just sucks out of the box and not in a good way.
Click to expand...
🤔

IDK man... Does the vacuum seem to pull a decent volume of air through the shroud behind the blade?
 
CalSgt said:
🤔

IDK man... Does the vacuum seem to pull a decent volume of air through the shroud behind the blade?
Click to expand...
It does. It’s a big ass blade though and a small port for the dust to go. It’s not bad on a 2x2 or 2x4 but anything bigger it starts going downhill.
 
You must log in or register to reply here.
Top Bottom