PSC BIG BORE and Teraflex HD Monster track bar

Zx14

New member
Hi all, anyone have this setup on there JK, is clearance ok? Mine looks close now with the stock box.
I also am running dynatrac prorock D44 up front.
Thx
 
I’d ditch the Teraflex track bar and get a Synergy or RockJock. And yes you may have clearance issues at full stuff depending on your setup.
 
I’d ditch the Teraflex track bar and get a Synergy or RockJock. And yes you may have clearance issues at full stuff depending on your setup.
Other than a “possible “ interference problem. What makes a synergy or rockjock better. Is your though just because the bushing vs Johnny joint?
 
Last edited:
Rockkrawler looks to the only one I can find that specifically says made to work with big bore pac box.
 
I'm a little late to this thread but , I'm running a ProRock 44 , PSC big bore box and a Teraflex monster track bar without any issues. I'm also running the HD steering from Teraflex and rancho hi steer knuckles. I just had the jeep on the alignment rack for some preventative maintenance and it really didn't need any adjustment , it was more like a checkup , all we really did was tighten the tie rod ends and grease everything. hope this helps
Matt
 
I'm a little late to this thread but , I'm running a ProRock 44 , PSC big bore box and a Teraflex monster track bar without any issues. I'm also running the HD steering from Teraflex and rancho hi steer knuckles. I just had the jeep on the alignment rack for some preventative maintenance and it really didn't need any adjustment , it was more like a checkup , all we really did was tighten the tie rod ends and grease everything. hope this helps
Matt
Agree, I now have an extra teraflex TB. clearances are the same with the rock jock.
 
For what it is I Run PSC with Barns 2.0 Alum TB and Flip the DL, 2017 Stock Dana 44. Held up great thru the Rubicon and Moab.
 

Attachments

  • PSC1.jpg
    PSC1.jpg
    145.7 KB · Views: 9
Top Bottom