JLUR Third Brake Light Bracket Screw Specs

Hello. 2020 JLUR. Does anyone know specs for the T25 screws that fit into the 7 holes in the third brake light bracket? 5 shorter screws, 2 longer screws. Also, how bout the 4 that fit into the spare tire mount arms below that bracket?

Finding it on Mopar site is proving difficult. So, any suggestions on where to find these little guys is appreciated. Greater Sacramento area or anywhere online.

Recently switched back to the original setup from a third brake light relocation. Lost all the screws. Thank you!
 

duktrx

Active Member
Hello. 2020 JLUR. Does anyone know specs for the T25 screws that fit into the 7 holes in the third brake light bracket? 5 shorter screws, 2 longer screws. Also, how bout the 4 that fit into the spare tire mount arms below that bracket?

Finding it on Mopar site is proving difficult. So, any suggestions on where to find these little guys is appreciated. Greater Sacramento area or anywhere online.

Recently switched back to the original setup from a third brake light relocation. Lost all the screws. Thank you!
Is it in this diagram?

Screenshot_20230305_084813_DuckDuckGo.jpg


Screenshot_20230305_085149_DuckDuckGo.jpg
 

jeeeep

Hooked
Hello. 2020 JLUR. Does anyone know specs for the T25 screws that fit into the 7 holes in the third brake light bracket? 5 shorter screws, 2 longer screws. Also, how bout the 4 that fit into the spare tire mount arms below that bracket?

Finding it on Mopar site is proving difficult. So, any suggestions on where to find these little guys is appreciated. Greater Sacramento area or anywhere online.

Recently switched back to the original setup from a third brake light relocation. Lost all the screws. Thank you!
the bolts that hold the mount to the body are M8x1.25x30 (13mm socket) fully threaded 8.8 or stronger

for the T25 screws, those are the same as trim screws. you could take one out of each side of the lower half posts where it slides onto and use those on the 2 bottoms of that face cover; for the short ones, stick a thin zip tie or paper clip to measure the depth then get some course thread stainless screws from the hardware store or order from amazon. If you have a variety of zip ties, you can also get an estimate of the width needed
 

kevman65

Hooked
the bolts that hold the mount to the body are M8x1.25x30 (13mm socket) fully threaded 8.8 or stronger

for the T25 screws, those are the same as trim screws. you could take one out of each side of the lower half posts where it slides onto and use those on the 2 bottoms of that face cover; for the short ones, stick a thin zip tie or paper clip to measure the depth then get some course thread stainless screws from the hardware store or order from amazon. If you have a variety of zip ties, you can also get an estimate of the width needed
Hell yeah, redneck engineering,

To the OP, just an FYI, MOPAR rapes you on any hardware. OCD be damned when they want $2-$4 per screw plus shipping.
 
the bolts that hold the mount to the body are M8x1.25x30 (13mm socket) fully threaded 8.8 or stronger

for the T25 screws, those are the same as trim screws. you could take one out of each side of the lower half posts where it slides onto and use those on the 2 bottoms of that face cover; for the short ones, stick a thin zip tie or paper clip to measure the depth then get some course thread stainless screws from the hardware store or order from amazon. If you have a variety of zip ties, you can also get an estimate of the width needed
Tremendously helpful. And in short order. to boot. That info is just the thing. Many thanks for specs and workarounds. Brilliant!
 
Top Bottom