Front upper adjustable control arms

[Oscar35]

I know it's not necessary but has anyone still put some in after installing EVO bolt-ons?

 

[OverlanderJK]

Just save for long arms if they are on your future.

 

[Oscar35]

Copy that. I was asking because It seems there might be some rubbing on the muffler when it's flexed. Thx tho

 

[OverlanderJK]

Copy that. I was asking because It seems there might be some rubbing on the muffler when it's flexed. Thx tho

Front or rear? How would the front run the muffler?

 

[Oscar35]

Sry, I meant the front DS hitting the crossmember bracket.

 

[OverlanderJK]

Sry, I meant the front DS hitting the crossmember bracket.

Factory driveshaft?

 

[Oscar35]

No I have upgraded both front and rear with JE REEL. Front what I've heard, there should be no issues. However, It looks pretty snug. I just wanted to see if anyone else ran into this problem.

 

[OverlanderJK]

No I have upgraded both front and rear with JE REEL. Front what I've heard, there should be no issues. However, It looks pretty snug. I just wanted to see if anyone else ran into this problem.

I'm pretty sure piginajeep has to run exhaust spacers with his bolt ons and aftermarket shafts. Probably because of the control arms. But it doesn't hurt anything.

 

[olram30]

There is a little heat shield under your shaft, since you have an after market shaft, and don't have the factory shaft with the plastic boot, you might try to remove it if you're exhaust has it. Might gain a little clearance

 

[Oscar35]

There is a little heat shield under your shaft, since you have an after market shaft, and don't have the factory shaft with the plastic boot, you might try to remove it if you're exhaust has it. Might gain a little clearance

Copy that. I'll give it a look. I'll also look into spacers.