Recent content by Trigg

Long story short. My brother turned 17 and I found him a 94 ZJ for $500. Absolutely Zero rust and Interior is a solid 8/10. PO originally said he bought it drove it home and let it set. It needed the tank dropped cause of bad gas. Well upon looking at the jeep I did my normal compression test...

I have the Synergy Steering system on my TJ and have a tie rod thats gone bad. Does anyone know of a parts store brand that will work? Ive ordered a new synergy one but I kinda need one until it gets in. Any help is appreciated, thanks!!!

My wife got broadsided the other night and went for a roll. Thankfully shes ok and my kids werent with her. The jeep is totalled. Thankfully the tow center let me remove everything before the insurance adjuster came out. Givin the damage my wife is only slightly sore ill give the jku a 5 star...

I had to break the passenger rear quarter window. I cant for the life of me find it. Does anyone know a place that carries them? I called the deslership and the guy on the phone couldnt understand what i was asking for.

Going to be putting 5x5 lug wheels on the TJ. I want to go with 1.25" spacers but I want to say there was a issue with the lugs being to long on the rear or something of that nature. Tried searching but couldn't find my exact question. Do 1.25" adapters require cutting of wheel lugs on TJ's...

I went to jump off my truck today and was holding rmp's at 2k and it started jumping to 2400-2600 rpms and dropping back to 2k. It seemed to do it every two seconds or so. I've looked for a vacuum leak and cant find anything, plugs have 20k on them and replaced TPS and crank position sensor 2...

I'll start from the beginning. I bought the jeep 5 years ago its a 02 TJ 4.0 Auto RC 3 inch lift with t-case drop everything else stock. Ran smooth as butter. A few weeks after buying I got stuck and went to put in 4low and got some grinding action . The next day I was getting a vibration from...

Did truck-lite change there designs? I've been searching for a few days for the model that was used in the Truck-lite Write Up but I cant seem to find them. Im not good with computers so I might not be searching the right things but all I keep finding are these. This and the Heated Version...

Had these on my TJ for about a year. Installed a Antirock a few months ago so no longer need. JKS 2.5"-6.0" Disconnects Finish has chipped and flaked off in a few areas on the arms and sway bar mounts. I disassembled them and cleaned all the threads, I purged all the old grease out and now...

So on this lovely rainy morning I drove my wife's jeep into work ( '12 JKU auto ) and the CEL came on. I busted out my handy-dandy code reader and got P0420 left bank CAT Eff. I viewed the live data and couldn't tell any noticeable laziness between the up and down streams during the switches...

Long story short got xd9000i and a disconnect lead. Installed the Power to the Alternator connector on the retarded 3 bank battery connection and the negative to well the negative post. Installed the winch connected the leads and nothing. I pulled the cover and made sure everything on the inside...

Hello from Virginia, I've been following on the site for awhile now and the help and knowledge on the site has been tremendous. Just noticed I hadn't given a introduction. Little bit about myself, I was born and raised in the hills of TN. After high school I joined the Marines, been in the gun...

So my wife comes home a few days ago and says that her Jeep is driving funny. Ya I know real specific. Long story short she has play in the Unit bearing and possibly a bad u-joint. So I have been doing some reading on Unit bearings and the differences from 07-11 and 12+. To be honest the only...

I found a box of these Tyco Relays. If I clip the Jumper from 85 to 86 will I be able to use these?