Front axel drive shaft yoke

[JeepinLife]

I understand it's a pretty specific way to change the front axel yoke. Anyone have experience with this?

 

[epetry]

I just did mine this week. Put a Adams 1310 in. For the front yoke I used a 3 arm gear puller and a rubber mallet. Came off nicely. Also the torque on that front nut is 160 ft lbs I believe.

 

[JeepinLife]

I just did mine this week. Put a Adams 1310 in. For the front yoke I used a 3 arm gear puller and a rubber mallet. Came off nicely. Also the torque on that front nut is 160 ft lbs I believe.

View attachment 158264

That's it? Nothing else special? Did you use a impact

 

[JeepinLife]

Just was wondering what the "very specific" way was thats noted in the write up for this. Im going to follow it but wanted to make sure I didn't leave anything important out.

 

[epetry]

That's it? Nothing else special? Did you use a impact

Used a impact 1/2 to take the nut off. Idk man I followed the instructions on Adams web site and another write up on here i did not have a problem but I guess I'll find out this weekend at uwharrie haha.

 

[epetry]

Here is the link to the install. The only special thing is the torque wench you will need to be able to properly torque everything.

http://www.adamsdriveshaftoffroad.com/front-jk-install/

 

[JeepinLife]

Here is the link to the install. The only special thing is the torque wench you will need to be able to properly torque everything.

http://www.adamsdriveshaftoffroad.com/front-jk-install/

Ok thanks. I've done the rear seems like it's about the same process. I just let my breaker bar lock up against my lower control arm and backed the jeep up in reverse. Spun the nut right off.