What was done to your rig this week?

[jeeeep]

Didn't like the gap between my Oracal tail lights and the bed. So i picked up some rubber seals to go around the tails. I used these from Amazon.

https://www.amazon.com/dp/B0BK83RSZH?ref_=pe_123509780_1038749300_t_fed_asin_title

Without seals:
View attachment 432847
with seal on:

View attachment 432848

I took the pic before tightening it all the way down.

That looks much better.

I have a set, installed one and took it off immediately because of the gap, will order the same trim and install them again.

 

[Aceisback]

That looks much better.

I have a set, installed one and took it off immediately because of the gap, will order the same trim and install them again.

The trick to that gap is to push up and in while tightening from behind.
That trim does still dress it up nicely, and provides some more dust and moisture protection.

 

[Aceisback]

Didn't like the gap between my Oracal tail lights and the bed. So i picked up some rubber seals to go around the tails. I used these from Amazon.

https://www.amazon.com/dp/B0BK83RSZH?ref_=pe_123509780_1038749300_t_fed_asin_title

Without seals:
View attachment 432847
with seal on:

View attachment 432848

I took the pic before tightening it all the way down.

What kind of seal did you use to close those damn gaps around the fenders?

 

[DFanning]

What kind of seal did you use to close those damn gaps around the fenders?

Dirt! Seriously, I didn't fool with it.

 

[Cagle]

Looks great!

Thank you

 

[epriev]

No pictures, but now in the 500 mile break in for Yukon 4.88s

 

[Launch]

I'll post some pics this weekend when my new rear bumper gets here. Destroyed my factory one at Jeeptoberfest last weekend. Caught the lower part of the bumper on a boulder and ripped it up pretty good. Ah the need for the bobbed bed.