Voyage of The Black Gypsy

Installing the half doors was straightforward as I’d hope. Now I can drive to Moab with them on and easily pull them off before hitting the trails. Waiting for the upper doors to be shipped.
IMG_1138.jpeg
IMG_1134.jpeg
IMG_1136.jpeg

I know it doesn’t make sense to remove the hardtop and doors to be stored away for the upcoming winter but hey, I drive a Jeep!IMG_1131.jpeg
 
After siphoning the gas from the tank, I was able to lower the rusted out skid and support the tank with a strap. There was enough dried mud and sand trapped by the skid and tank to almost fill a 5 gallon bucket
IMG_1171.jpeg

Now that the new skid is in
IMG_1172.jpeg
I can start installing the rear axle
 
Rear axle is assembled and, with the exception of torquing the control arms & track bar, installation is complete. Need to get new diff cover bolts to install the diff cover and service the diff with gear oil
IMG_1229.jpeg
IMG_1230.jpeg

Got the hydraulic hoses for the ram assist installed on the steering gearbox
IMG_1224.jpeg

Now I’ve got to get the front axle paid for so I can install it and get my Jeep back on the trail. It’s been too long!
 
We were given s half day off from work today, so I was able to get some more work done.

Brake discs, calipers and driveshaftIMG_1351.jpeg

Did a rough adjustment of the assist ramIMG_1360.jpeg
Might have to add a washer to the steering stops. I’ll check again after getting the track bar and drag link install and align the front end.
IMG_1362.jpeg

Man, I can’t wait to finish and get to drive her!
 
Last edited:
You must log in or register to reply here.
Top Bottom