Trail JK’s pretty Penny Copperhead build

Looks really good. Completes the rear end (so to speak). ;)

Did you wire those lights up yet? I was wondering how bright they are.

Cute butt! Cute butt! Lol

Not yet, I'll post a pic when I do; need to pick up a spade connector. I'm going to run it to a switch this time for off road lights. On the last Jeep they were used as additional back up lights.

bumper looks great!:thumb:

Thanks! 😊
 
Cute butt! Cute butt! Lol

Not yet, I'll post a pic when I do; need to pick up a spade connector. I'm going to run it to a switch this time for off road lights. On the last Jeep they were used as additional back up lights

:)

I went with the flush mount Rigids and wired them to a switch. They are amber and didn't think they'd do me any good to wire them into my reverse lights
 
:)

I went with the flush mount Rigids and wired them to a switch. They are amber and didn't think they'd do me any good to wire them into my reverse lights

Smart going with the amber. I like the look of both the Rigids and the round.
 
Pre-fitting of the cage is done and it's at a shop getting powder coated. If all goes to plan the install will happen this weekend. Yay!

ImageUploadedByWAYALIFE1427852055.379356.jpg.
 
Top Bottom