Switch Panel systems

Joey1313

New member
Being new to all this Jeep stuff, the options for parts are staggering. I am looking at a switch panel system to cleanup wiring. I am not good with wiring and never have been. What do y'all use and how do you like it? This is what I've been looking at.
SPod seems nice but pretty expensive. Might be best?
Switch Pros also nice and cheaper than SPod until you factor in really needing a PowerTray and then the price gap closes but maybe just as nice as SPod?
AuxBeam - More budget friendly but also appears to not be as robust as the above
Diode Dynamics - Price seems ok but large box and seems complicated
Any others I should look at?

I am leaning towards the SwitchPros and a PowerTray.

I know this is subjective but it never hurts to get opinions from people who have actually used some of this.
 
I have installed a lot of the spod models over the last few years. They are prob the easiest to install and wire to IMO.

Runner up would prob be the Garmin system. I have done a few of those towards the end of last year and they are simple as well and seem to work well. The only downside to them is they only seem to have 6 switch functions compared to the 8 with the spod. Those 6 fill up quick especially if you have your air compressor and air lockers on them
 
Upvote 0
I have installed a lot of the spod models over the last few years. They are prob the easiest to install and wire to IMO.

Runner up would prob be the Garmin system. I have done a few of those towards the end of last year and they are simple as well and seem to work well. The only downside to them is they only seem to have 6 switch functions compared to the 8 with the spod. Those 6 fill up quick especially if you have your air compressor and air lockers on them
Thank you for the reply. This is what I was looking for. I haven't looked at the Garmin but really would like 8 switches. SPod to the top of the list.
 
Upvote 0
Top Bottom