Sheet metal repair

[tippedover]

Been out of the country for 2 months with work, get back and first weekend out got a little ding.
The rivets on my rear fender got pulled out and the holes that they connected in got stretched out. Never had any repairs like this was wondering if anyone has repaired an issue like this and could point me in the right direction.
Was thinking redrill and just put new rivets in but I don't know if that would take cause I would have to drill through the fender and new wholes in the side wall next to the previous damage.


Sent from my iPhone using WAYALIFE mobile app

 

[black pearl]

I would flatten it back out and re drill. Unless you can get bigger rivets, if there is enough to re round the previous holes


Sent from my iPhone using WAYALIFE mobile app

 

[jesse3638]

I would flatten it back out and re drill. Unless you can get bigger rivets, if there is enough to re round the previous holes


Sent from my iPhone using WAYALIFE mobile app

This. Otherwise you may need to put a few tack welds in the holes to fill them in and re-drill them. This is why I'm happy with my stock cut fenders.

Sent from my 831C using WAYALIFE mobile app

 

[jeeeep]

bolted in place? i'd look at thin sheet nutsert inserts

 

[enfielded0405]

Could you pound it flat and then use fender washers on both sides?


Sent from my iPhone using WAYALIFE mobile app

 

[tippedover]

Ya the washers would be tuff cause as far as I know you couldn't get to the back side to tighten with a bolt. Thinking the tac weld idea with bigger rivets might be the best play. Thx for the input guys


Sent from my iPhone using WAYALIFE mobile app

 

[enfielded0405]

In the past I have JB welded a nut to a fender washer in tight spaces. Not sure how those mount those. I am still running factory fenders.


Sent from my iPhone using WAYALIFE mobile app