Pro Eagle mounting on a Decked box

[RCC]

I have a Pro Eagle jack and mount. I am wanting to mount it to my Decked box.

This the jack mount-



I had ordered an extra set of rails when I ordered from Decked but now realize the recesses in the box aren’t wide enough to fit the rails. I had also ordered some nuts that lock in to the rails.



Since my initial plan will not work I am thinking about using the 3 divots(they mark with there is steel structure) on the drivers side towards the cab as seen in this picture, I would take measurements and drill the corresponding holes in the jack mount-



The mount would sit like this in the bed. I think I need to mount it drivers side due to pull pin that secures the jack-



Thoughts?

 

[Dale72]

It might work. I just ordered the Decked System for mine Friday night

 

[wjtstudios]

You can flip the pin side, I had to on mine. Those bolt points should be fine, but if you could add one to the other end it might keep it from bouncing on the trail and keep it quieter.