Greasing lower ProSteer ball joint

MacRubi2

New member
Quick question...
How much grease does this take?
I have the needle to grease it but when I tried I couldn't really pump any in.
Is there any trick to this?
 
Quick question...
How much grease does this take?
I have the needle to grease it but when I tried I couldn't really pump any in.
Is there any trick to this?

Put it in and pump till you see some grease push out by the stud. Just watch it and pump slowly
 
Try turning the wheel a little the other way. If that doesn't work, jack up front end and have someone slowly turn wheel as you pump it. It will go
 
Try turning the wheel a little the other way. If that doesn't work, jack up front end and have someone slowly turn wheel as you pump it. It will go

Cool I will give this try

Yeah I was thinking that you might be able to change the zirk if the needle one threads out because I seem to have plenty of room in my ProRock44 to fit the grease gun in but I would rather not screw with it if I don't have to
 
Last edited:
I wouldn't take that needle zerk out. You can get it to take grease. It doesn't take much at all. Just move the joint a little and it will pop and start taking it.
 
Top Bottom