Skid_Kid
New member
Ok this thread is more for the sway bar disconnect drilling and remounting. The pictures in the instructions are kinda dark, so I went ahead and asked MTG where his was mounted. Also called EVO MFG this morning to confirm as the instructions don't mention removing a bolt to drill the 1/2 inch with a 1/2 inch drill bit.
Here is the bolt you first remove to rotate the disconnect.

Here is the bolt you remove to drill your 1/2 inch with your 1/2 inch drill bit.

Basically your just boring out this section to make the bolt from the rubber hanger fit in this location.

Sent from my iPhone using WAYALIFE mobile app
Here is the bolt you first remove to rotate the disconnect.

Here is the bolt you remove to drill your 1/2 inch with your 1/2 inch drill bit.

Basically your just boring out this section to make the bolt from the rubber hanger fit in this location.

Sent from my iPhone using WAYALIFE mobile app