EVO LA torque specs

[jeeeep]

I'm about to check the control arm bushings on the JLU EVO LA, EVO instructions state to use spec torque values but I'm over the additional degree torque values.
EVO also lists torque values for 9/16" bolts based on thread, pretty sure the bolts are stock metric JL bolts

Those of you with EVO LA, what torque value do you use?

I'm thinking about using the JK torque value of 125 FT#

 

[wayoflife]

With factory control arms, you really need to be tightening the lowers and rear uppers to 190 ft lbs. The front uppers should be 75-80 ft lbs. That said, 125-150 ft lbs should be good enough being that the long arms have Johnny Joints and don't require the same clamping force that clevite bushings require.