Orage_Jeeper
New member
Not to hack the thread at all but had a few questions regarding the same type of scenario. I'm planning on going from a D30 to a PR44 up in the front and I have called Dynatrac and Rusty's offroad (they're the closest to me) and I really wasn't able to get the question answered.
SO,
- Can I use the knuckles that are currently on the 30?
- If so then what do I do about axle shafts? Ive heard that you either have to go with RCV or reuse the D30 outers and if I reuse the D30 outers then do I need to buy a certain length inner shaft to fit with the D30 outer shaft and knuckles?
- Am I going about this wrong by trying to use the stock knuckles and outers?
Thanks!!!
SO,
- Can I use the knuckles that are currently on the 30?
- If so then what do I do about axle shafts? Ive heard that you either have to go with RCV or reuse the D30 outers and if I reuse the D30 outers then do I need to buy a certain length inner shaft to fit with the D30 outer shaft and knuckles?
- Am I going about this wrong by trying to use the stock knuckles and outers?
Thanks!!!