J
JKDream
Guest
First post
Building a Dana 44 for my JK, was swapping over the parts from a Dana 30 (knuckles) and had pulled the shafts out.
The front drivers side does not want to go back in.
Tried rotating the pinion, but it does not want to fully seat.
I can get the axle about 1/4 the way into the locker, then it just stops dead.
Any ideas?
Building a Dana 44 for my JK, was swapping over the parts from a Dana 30 (knuckles) and had pulled the shafts out.
The front drivers side does not want to go back in.
Tried rotating the pinion, but it does not want to fully seat.
I can get the axle about 1/4 the way into the locker, then it just stops dead.
Any ideas?