Arb switch location

Hey all. For those of you running ARB switches without an SPOD or similar device. How and where are you mounting your ARB switches? Pillars are out because I’m running a sport cage. Looking for something simple. Any ideas?
 

boardsurfer

Active Member
Left of steering wheel, above the speaker grill is probably the most common spot. Where the factory Rubicon switches would be if you had them.
 

WJCO

Meme King
No lockers on our JK, but we have the compressor on/off switch down at the bottom of the left side of the dash.

IMG_20170513_160141_615.jpg
 

jsukey

Member
I'm assuming you have electric windows. If not, this may work for you. My JK came ordered with factory half doors, so no electric windows. I mounted my switches into the radio bezel before I had my SPOD. After I bought my SPOD, I sealed up the holes with epoxy, painted it with flat black spray paint, then hit it with some rattle can, Dupli-Color Bed Liner.

10516874_10152313590858371_3398597374503091695_n.jpg
IMG_7407.JPG
 

desertrunner

Active Member
20180115_164641.jpg

20180115_213208.jpg

A dremmil and some patients and mine turned out decent.
The wires behind the switches are a pretty tight fit but obviously plenty of people make it work just fine.

Sent from my SAMSUNG-SM-G890A using WAYALIFE mobile app
 

Brute

Hooked
arb.jpg

Although I think the best location is on the front dash somewhere or in a Switchpro's panel (or something similar, here is another possible location...center console

I'm going to have to look into the Sasquatch switch...
 
Top Bottom