yes the EVO MFG ALUM. REAR Corner Skins will hold the EVO MFG Tire Carrier.
yes the EVO MFG ALUM. REAR Corner Skins will hold the EVO MFG Tire Carrier.
can the skins be anodized?
Maybe. I been looking at the evo a bit more. Now, i like the fact that aev opens with the gate and holds fuel tucked up in a nice place, however i came down on it pretty hard navigating the old sluice on the rubicon. Just about took the tire off the carrier. Also the bolt that secures the spindle to the housing is chewed up bad because its location. With that said not sure about the aev at this point.
hmm I may have to sell my steel ones and get the alum set so I can make mounting up the genright side plate easier
Did you think of cutting around the plate
The EVO carrier isn't as easy to open/close but it is solid as a rock and doesn't rattle one bit with a 40" tire.
My wife has no problems with it. I can't say it's hard at all
My wife has no problems with it. I can't say it's hard at all
Now I'd like to see EVO come out with an aluminum Tire carrier. :clap2:
I wonder how they're going to look unpainted after a few years.
Sent from my VS980 4G using WAYALIFE mobile app
Im powder coating mine. Anvil and raw aluminum=blah. But thats just me. I wonder if the install will be a little easier with the aluminum.