Search results

Seems all V8 swaps I see are with automatics. Any swaps available that I can keep my 6 speed? Need the extra power when moving up to 40’s Sent from my iPhone using WAYALIFE

I’m at the entrance to Hells Revenge in Moab and there are 4 JL diesels in the parking lot with manufacturer plates getting ready to run it. I couldn’t get a peek under the hood but they sounded nice. Sent from my iPhone using WAYALIFE mobile app

Installing my Enforcer kit tomorrow and I was looking at the control arms. I know how to adjust them, I just don’t understand what jams up against the Johnny Joint to tighten it up. I know the pinch bolt secures the adjustment sleeve, but what stops the Johnny Joint from moving? Probably a dumb...

After 2 seasons of wheeling my Rockhard engine skid is crushed enough that it should be replaced soon. I do like the skid but I need to find something a little stronger. Is there anything out there a little thicker or more resistant to bowing in? Sent from my iPhone using WAYALIFE mobile app

Last summer I installed one of Dynatracs hard core axle sets. The front came with the hydro assist ram mount integrated into the axle housing below the track mount, directly behind the tie rod. This is lower than a lot of the other mounts I’ve seen while searching and seems like it won’t have...

Wondering if hubcentric rings are recommended or not necessary? Getting ready to install 8 lug Hutchinsons on some Prorocks. I know the lug nuts will somewhat center everything up, but will it be enough alone to not exaggerate any balance issues with the heavy tire/wheel combo?

Anyone dealing with Hanson Off-road? I ordered their rear bumper in March and they charged my card. I waited about a month before contacting them to find out the status and was told "it's at the power coater and will ship next week". That was in April and I was told that once a week until June...

Just pulled my rear wheel well liners and trimmed the fenders in anticipation of moving up to 37's. I noticed many don't paint the wheel wells, but with having a white jeep they really stand out. Just wondering what everyone is using to paint the wheel wells? I am considering rubberized...

Is 9/16 standard? What length lug nuts are recommended?

Trying to finish plumbing my dual ARB. The fitting and leader hose that came with the manifold is a -4 and seems awfully restrictive. I have some Goodyear nylon air brake hose with an inner diameter of 3/8" I'd like to use to plumb but to my air tank. My question is how will that hose hold up to...

Just mounted a dual ARB under my seat and now I want to plumb it to my air tank underneath. If it runs hot like my last compressor I worry about the hose not holding up. What's a good hose to use that is not too bulky and will hold up to the heat and pressure? The JIC4 fitting that they supply...

Looking to buy 2 bad axle lock sensors, actually I only really need the connectors and pigtails. Looking to bypass and don't want to splice or cut my good ones. Thanks.

I have a spare box I'm getting ready to tap for hydro. I know the locations I need to drill, I found a write-up that explains it pretty well but they drill it without disassembling it and I was wondering if that was acceptable or if it was a better idea to take it apart. I don't want to create...

Going to be mounting my twin ARB, under my passenger seat most likely, for the lockers. The only concern I have is how often it start up, I don't want to keep scaring the shit out of my girlfriend. I'll probably add a 1 gallon tank behind the drivers seat. Assuming the volume of the tank, and no...

I've been saving up for a pr44/60 combo for awhile then Dynatrac comes out with their combo packages and the 60/60 combo is hard to resist. The 60/60 is more than I need, but you get so much more for the extra $1500 and I'm trying to convince myself to go for it. The biggest issue is the...