Search results

Finally the atlas 4 speed fits and is bolted into place

Pulled the console and seats to prep for install atlas shifters. Started cutting the floor to fit the atlas. But didn't take any pictures.

Flat belly for this pos

Very nicely done. 05+ superduty axles are a pain in the ass to work on.

Wasn't expecting these this soon

Badass kingin C's and knuckles. I wanted to do that on my build but cheaped out. Wheels and tires look go too! :thumb:

Worked on the Jeep for a while on Monday and a little on Tuesday to decide that I'm not gonna use anything I made. Wasn't happy with the direction I was heading and long story short I'm gonna completely flat bell the jeep. Ordered some d.o.m. bushing sleeves that I will use use to make a new...

Worked on the jeep some today. Full hydro is pretty much completely plumbed. (Other than cooler bc I ordered another one) And I start taking brake lines and other junk off the back getting ready for back half.

Unfortunately didn't work on the jeep today but i did order a different power steering cooler (long story). And ordered seats! Ended up getting 2 Corbeau baja ultra with a mix of vinyl and cloth. Hopefully they will be in pretty soon and I can really start getting the cage and back half going...

Worked on the jeep a little today. Mounted the orbital, installed my oversized brake master, ran the feed line to the pump and started running the pump output to orbital line.

Last night I bolted in the psc pump, resi, and ram. Still need to mount the orbital and then make the hydro lines.

Nice. Looking good!

Front end is fully pained and assembled! Took 28 days but making progress. I started with notching the crossmember under the radiator for the hydro mount/truss. Then made a crossmember out of a 2"X2" 3/16 thick square tube. Probably not all that necessity but since I took most of the strength...

Continued to work on the piece today. Finished welding ram mount and made a crossover bar for the strut towers. Its incredibly close to hitting the hood if not sits on it a little but it will just help protect radiator in a roll and help hood from caving in as bad. Then started painting everything

Ended up working on the jeep some more. Pulled the front axle back out and started setting up the steering. Still need to do some more welding and then paint and finial assembly.

Pulled the t-case today in prep for putting in the atlas. Also cut the body again to where i thought would be my final cut line and started to drill the floor out to run the cage to the frame. But now I'm thinking about going back to plan A and cutting the rockers and everything off, boatsides...

Pulled the gas tank, evap, rear driveshaft, and the rest of the exhaust out. Gonna need to install the atlas then its time for back half and rear suspension.

I've been using a miller 212 for the past couple years and it had been pretty flawless. I have built a Toyota crawler with it and I am now building my jk buggy with it.

Nice. Looks good

She sack back on all 4s today! Got the drive shaft issue solved. Had to change the mounting point of my upper control arm closer to the floor. Its gonna change my anti-squat/dive number but don't think it'll really have a negative affect. Almost changed my pinion angle a little. Should clear now