Recent content by TheMistress

Just picked these up.

I was going to post up the evo track bar, fender liners and sway bar motor in the recycler section but I'm not cool enough yet it won't let me post there. 😥

Riot Beadlocks. I opted for the matte bronze with black ring.

Almost done. Got the evo enforcer pro stage 4 plus all in. Evo fender liners, evo tire carrier, evo sliders, Black rhino beadlocks with some toyo rubber. Synergy drag link, track bar, tie rod, sector shaft brace, warn winch. Baja designs onyx 6 bar, arb compressor mounted with Eddie's ACM and...

All it takes is money

This is a good point. I can adjust caster when evo decides to ship out the control arms. Hopefully this year.

My entire wallet.

On the mistress 1.0 I ran 15psi because I had no beadlocks. The mistress 2.0 with the beadlocks has yet to hit a trail. Sand Hollow in 2 weeks!

It was so cross threaded in there that it still held!

If the K and N cabin filter is 'high flow' like the intake filters I wouldn't run it. The only way to get high flow is to filter out less particles. We make our intakes here at work with K and N filters and I wont run it on my jeep and I don't have to pay for it!

Welcome, also from so cal

Jeep is finally up and drivable. I took it down for an alignment just to see how close me and MericaMade got it. I still have a pull to the right and cant figure that one out. Any of you degents have any thoughts or guidance?

good thing my dainty little hands were able to get the sensor off.

👋 from CA

Welcome. Can't wait to see the build