So I have been searching far and wide for a rubi trans for a manual.
Mopar overstock has some but I am unsure which one to order.
They have different descriptions which confuse me.
One says shift on the fly and one says rock Trac part time 4wd.
They are no help on the phone as they want a vin...
So I had some prosteers installed a few months ago.
Today I am swapping in some Rancho high steer knuckles and noticed something weird.
On the driver side the bottom ball joints has no movement, top has a little.
No big deal right.... well on the passenger side it's just the opposite, lower...
Just wanted to give a shout out to Don, Matt and Patrick for the great service.
Sent a PM about getting some new 37s. Don and Matt replied and set it up to have Patrick call to take my order.
Patrick called me on a Saturday and took my order, tires are showing to be delivered today.
They even...
Went out in search of some old mines south of Mesquite nevada. Over 100 miles of dirt roads to get into this area.
Stopped close to a area called Whitney pockets to air down.
Had to squeeze thru a small gap to get to the next location. We were in search of a Arastra, which is a primative...
I am looking to add some seat heaters but was wondering if it's ok to cover the passenger side seat sensors or not?
I saw that some Mopar kits only come with one pad for the passenger side due to the sensors and 2 for the driver side.
Has anyone added them over the sensors?
Been having a small wobble/ shimmy between 42-47 mph. Everything is pretty new on the front. Had the tire balance checked . Soo I did the ball joints check. I don't think the upper is suppose to move this much sideways.
Click for Video.....
Anyone notice their diffs getting hot after regearing?
If so what did you do to help cool them.
Went from 3:21 to 5:13 and my diffs get to hot to even touch.
On my old jeep with 5:38's they got hot but not to where you couldn't even touch them. I ran 85-140 in them.
I am running 80-90 in these...
Well after almost 2 years without a jeep we decide to get back in one.
I wanted one with the newer motor and a 6 speed. Going be a bit of a learning curve with the clutch offroading but I have a few years of building before I go hardcore anyways.
So I found a 2015 sport with the 6 speed for a...
Is it possible to run hydro assist without a drag link flip?
My last jeep had a 4.5 lift with the drag link flip and I ran the redneck ram setup.
My new jeep I only planned on running a 2.5 lift. Wasn't planning on doing the drag link flip but know for sure I will need to be doing hydro...