Thanks for the suggestion. I tried putting two bolts in the yoke flange and a wrecking bar to hold it still while I used a breaker bar. I used about 5ft of tubing for cheaters on both and only flexed the breaker bar. The impact I ordered might be a little over kill. 1350ft-lb of torque.
. Pinion bearing preload is set. A little on the high side but still in tolerance. Axle shafts in and torqued.
It wasn't fun, still have the front to look forward to haha.
Those are the kind of tools everyone should aspire to own. Lol.
. Seats in the jeep. Might need to make the mounts a little more permanent.
That turned out to be not such a good idea lol. The first seat support is ready to be tacked in and tacked on the windshield cross member in.
Looking great! Looks taller than your garage door you going to be able to get it out lol
I measured the door a while ago and I think it was around 7"s of clearance. Worse comes to worse let the air out of the tires and take out the coilovers to rest on the bump stops.
still progress. Just need to fab up some brackets and set the angle I want.
