EVO Lower Control Arm Question

[Mdrnizd]

I've had to adjust my end links on my lower control arms to 23 1/4" to get my caster set to the 4 degrees or the 88 degrees on the angle finder. Is it okay to run the adjusters like this, or should I pull the control arms back off zero the adjuster out but unscrew the joint? When I had them set to 22 7/8" like the instructions said my angle finder said my diff was at 90 degrees so I unscrewed them to get to the 88 degrees. I hope that makes sense and I'm not confusing myself. Lol

 

[wayoflife]

You're confused and now have too much caster set. The 88° needs to be at the top of the angle finder - NOT the bottom as you are showing.

This is what you are wanting...

 

[Mdrnizd]

You're confused and now have too much caster set. The 88° needs to be at the top of the angle finder - NOT the bottom as you are showing.

This is what you are wanting...

That figures. Thanks! So if I would've needed to adjust the lower control arms out, is that how it works and then just tighten the upper jam bolt?

Thanks again!