Coast 1310 install

Sugarbear

Sugarbear

New member
Stupid question but how do I know when I install the coast front shaft that it's in right and that I won't have vibrations ?? Is there marks on it ??
 
Sugarbear said:
Stupid question but how do I know when I install the coast front shaft that it's in right and that I won't have vibrations ?? Is there marks on it ??
Click to expand...

eddies write up should answer most of your questions.
http://project-jk.com/jeep-jk-write...-front-1310-drive-shaft-installation-write-up

also make sure you install adjustable control arms to make sure your caster is set properly. here is the link on how to properly set it
http://project-jk.com/jeep-jk-write-ups/basic-do-it-yourself-jeep-jk-wrangler-front-end-alignment
 
Sugarbear said:
Stupid question but how do I know when I install the coast front shaft that it's in right and that I won't have vibrations ?? Is there marks on it ??
Click to expand...

I called Coast and asked them when I installed mine, as long as you don't separate the DS at the spline, the yoke doesn't have any marks and just bolt it up.
 
jeeeep said:
I called Coast and asked them when I installed mine, as long as you don't separate the DS at the spline, the yoke doesn't have any marks and just bolt it up.
Click to expand...

Forgive me but I don't quite understand this can u explain more??
 
Couldn't you make an alignment Mark on each half? A just in case kinda thing

Sent from my LG-D800 using WAYALIFE mobile app
 
OverlanderJK said:
I didn't do it on purpose lol. No lower control arms, wheels/tires and shocks allowed a lot of droop and it came apart. Was working on the rear axle when it happened.
Click to expand...

Was it a pain to get right again ? Or did u just put it back together and it was ok
 
You must log in or register to reply here.
Top Bottom