Search results

Anyone know the bolt and threaded insert size for ATX Chamber Pros / Slab beadlocks?? I see some post the cap screw is 3/8 X 1.5" and I believe a 16 pitch but does anyone know the exacts and also what inserts to use maybe even links to buy?? Also the proper insert tool to screw them in??

So, I just picked up my shiny new gladiator diesel Rubicon less than 2 hours after they gave it the recall fuel pump. So what's first?? I am thinking I should take my 37" Nitto Trail Grapplers on Beadlocks from my 2016 Wrangler and swap them with the Rubi wheels. But wondering if the Rubicon...

So, I know that the common thing is that just cut/trim the stock flares as there are many benefits that they can just tear away in a rumble with a rock... But, if I wanted to go with a tubular flare I am wondering about any input.... From what I have seen they range anywhere from about...

So I went to Firestone to have my jeep alignment done since I just put a fresh set of new 37" Nittos on it. They did the crowbar test on the front wheels to see if the ball joints have failed and sure enough it wiggled. Additionally, they noticed the lower ball joints the bolts literally were...

Magnaflow vs. MBRP vs. DynoMax Exhaust for Crawling.... I wanted to ask if anyone can give some good advice between using a Magnaflow or MBRP cat-back exhaust. I am looking for a rock crawling that would exit over the axle towards the rear... What is the thoughts on sound of these two...

Well I tried searching and could not find a thread for this so I will just start one.... Although one thread suggested getting a big Crescent wrench and just bending them. I have noticed on my JKU that I am ever so much beating the shit out of my poor body mount brackets... I have searched...

Okay.... So I am looking for a tire carrier for my 2016 JKU and while I was thinking of going with the EVO hinge carrier as a way to save a few dimes and be open to whatever bumper spikes my fancy I hear that may not be so good as if I start to weigh it down (ie, gas, hi-lift, etc...) it will...

Well I purchased my 2016 about a year ago.... Ordered it in Tank with virtually no options other than 4.10 with Auto and a hard top... I just got around to purchasing a whole ton of parts to make it more capable than stock for Black Friday specials... In a couple weeks I will be spending a...