Search results

Here's a link to some jamb nuts http://www.ebay.com/itm/7-8-18-ZINC-PLATED-TRE-JAM-NUT-RH-LH-FOR-ROD-ENDS-OFF-ROAD-4-LINK-SUSPENSION-/251689496814?hash=item3a99dcf0ee:g:aj4AAOSwF1dUSWz-&vxp=mtr

Tons of coil left. You can also see where I added more bump stop based on cycling the suspension yet the extra puck doesn't even begin to touch the rubber bump pad. I will keep an eye out for an opportunity to put it into a more of a CTI loading and see if it changes things. Not too worried...

Using Metalcloak arms. Here is pic of the upper rear passenger control arm hitting the frame while on an RTI ramp. The driver rear bumpstop still has several inches to go. The jam nut is right against the frame.

Hi guys, To make a long story short I have a rear trackbar relocation bracket already and the axle is fairly well centered but I need to tweak the axle a bit over to the passenger side. Was looking at the JKS bar but heard its longer than the OEM bar even when fully adjusted in. So I need a...

Hi guys, just bolted on but haven't tested yet the EVO front coil over kit. I notice now the coil overs allow more droop than my shocks did, enough so that my aftermarket front driveshaft will now hit that crossmember. Wont do it unless both sides of the axle are lowered to full drop. My coil...

Hey guys, the EVO Front bolt on coil overs require you to install brackets on the lower shock mounts to move the mounting points outwards a bit. My question is do I just discard those if I have a Dynatrac PR axle on front? The PR already moved the mounting points outward and they have a bit...

My schematic is stupid simple. Nothing to stop you from doing the same with an ARB, and another mentioned.

Ok, I've searched but not found anything definitive so here it goes.... Going to put it a PR44 already built up in my 13 JKU rubicon and sell off my current axle assembly complete. Was thinking about trying the Eaton 4 pin e locker in the new set-up. So my question is this: Can I use the...

Hi guys, would like to introduce myself. First time jeep owner and newbie to off roading in general. Im all grown up and always wanted one so I bit the bullet. She's a 2013 JKU rubicon. Picture is old but all I have on hand since she is currently half tore apart in the garage right now. So...

Guys, Messing around on the jeep and I noticed the bolt holes for my brake rotors are much larger than the bolts. It allows the rotor to rotate back and forth on the hub. Never seen that before. Did I get the wrong rotors? I bought the Jeep used so no idea if its stock but its a 2013 JKU...

Hi guys, Somewhat of a noob, as I will demonstrate with these questions. I have an 2013 JKU Rubi with a Metalcloak 3" lift. I noticed the front driveshaft contacts the cross brace and exhaust at full droop so I've ordered a new driveshaft. I hope this fixes that. Now for the rear I planned...