Search results

I was just wondering if any of you out there that have trailered your JK have any strong opinions as to whether a bumper pull or a gooseneck is better. I'm in the process of moving far far away from the good offroading destinations but will be making annual or biannual treks to moab and other...

For those of you that have actually weighed your '12 or newer JKUs, I'm wondering what they've tipped the scales at. Mine is a '13 JKUR with a basic coil spring set up, chromoly control arms, some aftermarket steel armor (fenders/rockers) with 37s on 17" aluminum wheels. All other major...

Has anyone used a commercial carrier to ship their Jeep before? In a couple of months I'm going to be moving across country and as much as I would love to do the road trip in my JK, time simply won't permit it. I was just wondering if anyone has any recommendations regarding good commercial...

My bad - I deleted some stuff "Fenceline" is technically North Pole on the map. It starts at the very top left of the map and runs down the entire upper edge of the map (there's more than enough room to run the trail in either direction though). The map leaves a lot to be desired, but it will...

Maybe melt was being a bit melodramatic...but there wasn't a sudden pop or anything like that. Granted, I wasn't exactly being smart about what I was doing at the time.

Tepees and huge arrows along route 160 near Mesa Verde National Park in Southern Colorado

Recently my right front turn signal has started going out. It works fine for about 10 seconds, then the "right front turn signal out" message pops up on the dash and sure enough, the light is not working. If I shut off the ignition and restart, it will work again for another 10 seconds and then...

I need to change out my rear diff fluid. Laying around my garage I have a quart of amsoil, a quart of royal purple and about half a quart of castrol synthetic. All are 75w-90. Is it ok to mix these?

Tawatec...because everyone has luminox. I love tritium watches and this one has been great for the past 5 years - I wear it daily, beat the heck out of it and it still works great.

Some Roadside America app sights from a recent trip between San Antonio and Dallas (along highway 281) An old petrified wood and stone speakeasy in Glen rose Texas Statue of billy the kid - the plaque has an interesting story. Hico TX Giant Spurs - Hico TX Giant catfish - Lampasas TX

If it's due to droop/exhaust contact, it will likely look like this. This happened suddenly while my front end was a full drop (3.5 inch lift). I replaced it with a 1310 Tatton drive shaft. In retrospect I shouldve gone with a 1350. I recently replaced my rear one with a brand new factory one...

So I just had my ball joints replaced, and on the way home from the shop, I noticed that when braking at highway speeds, my jeep is pulling pretty hard to the driver's side. It drives straight as an arrow otherwise. It doesn't seem to pull at all when braking below 40mph. The front rotors seem...

That's really cool

Has anyone else seen this? I know I know...the River Raider thing...but this is the first hellcat engine I've seen in a JK

So I'll start by saying that I'm completely new to working on my own jeep and am trying to learn. I recently tried installing some rock lights using the wayalife writeup. I used the platinum burner LED race lights (pic below). I used the switch that came with them since I don't have a daystar...

My wife and I were in big bend over thanksgiving week too. We stayed in la jitas (Pricey, but safe and highly recommended). We did the state park & the national park. Definitely had firearms on board and within easy reach. Here's some (admittedly crappy) videos I made - please don't expect WOL...

This morning I started my Jeep (13 JKU 18k miles) and pulled it out of the garage to install a set of rock lights. It started fine and sounded normal. Once the rock lights were installed (by the way Eddie, thanks for the great writeup on that), I started it up to put it back in the garage. In...

The day I got it...trying to figure out what the hell a "sway bar disconnect" did :blush: A little over a year (and a few mods) later I finally figured it out

B.A.D. Wheels 17x10 with 37" maxxis trepadors I love these wheels - they're a bit of a challenge to mount but once you get the first one done, they're not bad. The internal beadlock mechanism makes them "street legal" (with DOT Stamp inside the wheel) for what that's worth. I routinely run...

Just curious - what do you base this on? Are you running or have you installed MC fenders? Have you seen some fail to protect the tub on the trail? Maybe Poison Spyder or Gen-Right or whomever are just as good, but either way I'd reorder these fenders any day. The few pics (wish I had more)...