Search results

Just wanted to confirm and I did, everyone says you're a douchebag. I had been giving you the benefit of the doubt. Just like all the other contentious threads on this forum, they all end the same way. It's always explained by someone being a fanboy and you will belittle to no end. You truly are...

I just ordered 5 Toyo MT 35x12.5x17. Can I get some recommendations as starting point for air pressure? I went with the Toyo because of its heavier sidewall. Hope it's the right decision.

Finishing up a lift install and wanted to check what the difference between the driveshaft angle and pinion angle should be. Seems like a remember 2 degrees down or parallel. Thanks in advance.

Hey everyone, glad to be here. I'm on my second jeep, a 2014 Billet JKUR. I had it wheeling once at Superlift ORV in Arkansas. Right now I'm in the middle of installing a 3 inch lift with CAs. Just posted a drive shaft question. My first Jeep remained stock so this is all new for me. Hope you...

I removed the stock flange to install a new pinion yoke and it has a dust cover for the seal. The seal cover is pressed on to the stock flange and the new yoke has nothing. I attached a picture. Is it correct to install the new yoke as is? I will grease outside and put some silicone on splines...