Recent content by jk12blk

  1. jk12blk

    Count me on the no more business with Northridge train

    Seems pretty clear to me. Read the policy before you go off on a company. :naw:
  2. jk12blk

    Build Shops in San Francisco Bay Area

    Take it to Mike Shaffer at Shaffer's Offroad in Alameda. Great shop and Mike is a great dude. Or, bring it up to Sacto area - tons of great shops up here. I would recommend either Offroad Addiction (Newcastle) or WFO Concepts (Auburn). Metalcloak does installs too (Cloakworks) if you go that...
  3. jk12blk

    Best Drag Link and Tie Rods kit???

    x2. Fusion 4x4 for the win. Great company too.
  4. jk12blk

    Bed mounted spare or none at all?

    Over three years now and I can tell you from experience it works great. Recommend removing the rear seat. There is plenty of room for all your food and beverage, tools, parts, etc (most of which I pack low behind the front seats). Lighter stuff like clothes, chairs, tents can easily be packed up...
  5. jk12blk

    Full cages - let's see them

    Check out Synergy/Poly Performance. They offer the A, B, and C pillar as weld in. Here are a few photos to give you an idea. The A and B have frame tie ins (A frame tie shown in the pic below). The B pillar is basically a couple down tubes that weld to a floor plate like A and also includes a...
  6. jk12blk

    FLEX FRIDAY!! Let's See Pics of your Jeep Twisted Up!!

    decided to hit the Rubicon this afternoon....
  7. jk12blk

    E-brake help!

    You can try disconnecting the cables from inside under the console to free up some slack so you can connect the wheel end first. Then reconnect the cables inside the jeep by pulling the cable connector back far enough so you can re-connect the cables. I recently installed new custom axles and...
  8. jk12blk

    Burner's Build

  9. jk12blk

    Burner's Build

    more pics earlier on in the project.. The tire pressure figure is bogus - not sure why it has a reading as TPMS is disabled.
  10. jk12blk

    Burner's Build

    I'm happy to report that everything worked out as planned! I must admit, I was a little concerned about the speed sensors and gear ratio, but it all checked out and I drove my jeep home yesterday. To address the change in tone ring tooth count (52 changing to 60), i had to calculate the...
  11. jk12blk

    Burner's Build

    Sorry, did not mean to imply I'm doing the welding. Dylan (owner of Offroad Addiction, Auburn CA) does all the work. You would have to ask him. My welding skills stop with J-B. :yup: Actually, based on one of the photos it looks like they are using a large Millermatic 210. He may have more...
  12. jk12blk

    Burner's Build

    little weld porn...
  13. jk12blk

    Burner's Build

    Stopped by to drop off a few parts and took a few pics today. The Coleman racing rotors, hats, caliper mounts and calipers also arrived today. Custom RCV's arrive tomorrow.
  14. jk12blk

    Burner's Build

    Dylan and team at Offroad Addiction are off to a great start this week with tacking up the mounts, cycling the suspension, etc - all in prep for final assembly next week. The synergy draglink will be replaced by Fusion4x4's draglink and the AGR ram will likely be replaced due to the stroke being...
Top Bottom