Im a charcoal kinda guy. I use a charbroil grill that i pulled the gas burners out of. Tonight its a good ol drunk chicken cooked with indirect heat.
Sent from my LGLS991 using WAYALIFE mobile app
I haven't been able to work on this thing as much as I'd like here lately. I started a new job with the department of corrections, and it has been a big change to the schedule I'm used to keeping. No longer can i sit in the house until my wife goes to bed, then head out to the garage until 2 or...
Yet another reason to keep it safe, and wait until your at camp to crack one open.
Things like this put a black eye on our community, and it sucks that we have to see this to maybe wise up
http://www.mtdemocrat.com/news/dui-suspected-in-fatal-jeep-rollover-on-the-rubicon/
Sent from my...
That particular step is an add on. They did however offer a factory step that looked like this. Im really glad to see a resurgence of cj's on here.
Sent from my LGLS991 using WAYALIFE mobile app
Got the new trans in tonight, still need to come up with a new th400 to dana 20 adapter, they seem to be rarer than hens teeth. Also did some finish welding on the sliders. I need to move the rear kicker on the drivers side to match the passenger side. Yes the driver side slider is kicked up a...
I know its a long shot, but does anyone have a th400 to dana 20 adapter laying around. This setup could be found in j-trucks, waggys, and commandos. Thanks in advance.
Sent from my LGLS991 using WAYALIFE mobile app
Here is a 1st gear clutch and steel compared to a 3rd gear clutch and steel out of the same transmission.
You can still see the numbers on the 3rd gear clutches.
Sent from my LGLS991 using WAYALIFE mobile app
Here's a little fyi. Automatic transmission clutches and steels are not supposed to look like this. Safe to say that trans was roached
Sent from my LGLS991 using WAYALIFE mobile app
Split the trans and t-case and found a bit of carnage. The lip that the snap ring seats in busted and the snap ring and what was left of the casting were dangling from the trans output shaft.
Sent from my LGLS991 using WAYALIFE mobile app
Im running jk take offs 32" with a 2.5" front and 2" rear spacer kit. I still had to trim a touch off the bumper cover and inner fender to avoid rubbing. I have a 4" lift laying in the floor, just no time to install it.
Sent from my LGLS991 using WAYALIFE mobile app
For sale is an exceptionally clean 2000 jeep grand cherokee. It has the 4.0 straight 6 with 122k on the clock. It is 4x4 with the highly desirable selec-trac transfer case that gives the driver options of 2wd 4hi 4lo and awd. It has full leather interior that shows minimal wear with power...