GoMopar440's latest activity

Replacement plug arrived today. Hopefully this amount of protrusion will clear the body tub. If not, I'll look into that box idea.

😆

I painted the spacer with the same spray on truck bed liner I used on the front bumper.

Today I picked up a 1" PVC connector from the electrical conduit section at Lowe's. It needed a bit of trimming for length and inside...

If the box is placed over the holes, then no one will see the mistake.

That would be a better solution... if done before drilling those holes. Since I did more assuming than measuring before I started...

Ok, good news/bad news today. The Good: The USB and 12v power ports arrived today, two days earlier than expected. I was able to start...

My Jeep didn't come with a rear cargo area 12v power port, so I'm going to add some ports of my own. I'm adding a cargo area 12V socket...

The digital rearview mirror arrived in the mail today and I already have the mirror and wires to the rear mostly installed. All I have...

I just ordered a 4K rear view mirror display with a rear camera. The mirror itself also has a forward facing dash cam built into it and...

Good light cut off and amazingly noticeable light even when the sunlight is just starting to fade. With the old lights it would have to...

Found a little surprise while I was taking out the side light on the driver side... I guess when in Rome... No issues with the...

Fogs are in. I'll get to the fender lights tomorrow.

More pics... The fog lights need some nuts and bolts to mount them, so I'll get those tomorrow. I also need to install the front fender...

There's lots of how-to's on installing these kind of LEDs, so I'll just post a few pics of the before, during and after.