epriev's latest activity

Okay, I know there are more than a few of you who've looked at GLUETREAD and I know it because I certainly have and even went so far as...

Outlawed the exhaust or broken truck stance?

Are the fenders the same height. Currently the front is 42 inches, the back is 39.5 so 2.5 inch change... I didnt measure before the...

Front half done. Didn't have time tonight to do the back.

I was more focused on getting the lift on. I may try again and take pictures. But laying on the floor struggling to get these to work...

I didnt take any. Hands covered in grit.

So I got the front don't minus the sway bar links. The videos were very helpful. Took me about 9 hours just for the front. It was...

So today I installed the front of the evo susyspension, but gave up on these brackets. I only attempted the drivers side. I could get...

Me personally, I can do the whole lift in about 4 hours. However, I think for most people, it would take at least 8. I would plan for a...

Thanks. The wrangler suspension is very different than what I had on the solid axle swapped xterra. Realistically, how long did it...

I used an ebay listing from a KY dealership when I bought my 350z. They had 3 Nismo editions listed for model life clearance since the...

A coworker wanted to see how I wired my new winch. I showed and he asked where the cutoff switch and fuse where after he saw it wired...

Honestly, it really isn't necessary. Without it, your axle will be a little off center at ride height but then, it's always off center...

A crescent wrench will work in place of a 24mm It's not critical to have. If you plan on doing a lot of big flexing on the trail, it...

I have a Harbor Frieght 5 minutes from me and they had a set with it for $20. It is not included in the 2.5 inch kit. Should I order a...