Recent content by Benito

Morals and Ethics? All this talk about morals and ethics but nobody said anything when 4WP signed up as an approved vender. We all know about the shitty work they put out and all the shitty products they sell, yet they got to advertise here. Or that time when Fishbone off road was a vender and...

Your skid should be parallel to the ground and should have the long edge welded to the axle tube Something like this: Your trackbar ibas to be raised to be most parallel as possible to the draglink. The frame notch was probably done to accommodate the draglink which is now higher. Some...

Evo Highsteer Skid and Trackbar bracket with custom Exodus Jeeps steering links I think that having the ram on the original cast steering arm alleviate the need for the double sheer, I havnt had any issues

Route them through the frame You just have to gently bend the hardline a little bit.

The Evo carrier actually transfers all of the weight to the hinges. Once you have the new brackets installed and the tire carrier installed, you could actually not run a tailgate and just run the carrier, the tail gate mounts to the new carrier. Holding the carrier in the closed position would...

Back when I had my d44, I ran two 90* fittings off of the ram towards the passenger tire, looped back after the tierod bracket and zip tied both lines back up the trackbar, and left minimal slack to go back towards the box with a straight fitting and a 30* fitting I believe Two different Jeeps...

When one steering stabilizer isn’t enough, and 2 still don’t do the job, you run 3 of those bitches

Nemesis Fenders are absolutely fabulous looking. I am definitely more careful when I wheel since I have seen what happens when they get hung up on something, not good. But damn do they look good

I wonder what they mean by bigger axles?

I was running into the exact same issue until the unit bearing finally failed on me with almost no sign, a combination of bad roads and having hydro assist. I was traveling and was pulling off the highway to get gas. My brakes went to the floor but I was able to build pressure again to stop. the...

I’ve had to trim quite a bit, and still trimmed a little bit more after this Sent from my iPhone using WAYALIFE mobile app

The axle tube is two pieces coupled with cast sleeve that houses the disconnect motor Video screen shot from JCR YouTube video

Here’s my Poison Spider sport cage, I had it powder coated with a color really close to Gobi I also powder coated my Evo tire carrier, you can see how close/off it is a little more

These are my color matched flares, they looked good, I just sanded the rough edge

Why not glue some door trim or something on the spring perch?