ProSteer/Reid Knuckle HELP!

[Strike Force Zebra]

I'm in the process of rebuilding my 08 JKU and wrapping up my front 44 build. I've replaced my ball joints with ProSteer's and installing my new Reid Knuckles. I torqued the castle nuts down in sequence as instructed and to the ft lb's instructed. And I still have a gap between the top of the top part of the knuckle and the bottom of the top ball joint. I seated the ball joints all the way too. :clap2: The bottom ones look fine. Should I be worried? Help!

 

[JKAnimal]

That's the way my pro-steers sit. The factory ball joints have a rubber gasket that hides the space. That's why you don't see it with the factory ball joints.


WAYALIFE APP

 

[Strike Force Zebra]

Good to know! I saw a picture on their page and wondered if it was just that gap where a sleeve would be.. Thanks!

 

[JKAnimal]

I did the same thing when input mine on. I was like wtf? Then I found some pics




WAYALIFE APP

 

[Strike Force Zebra]

I had left a message at Dynatrac early this morning. They got back to me and informed me the same.. It's normal and ok. I had done the same with Reid. Passed emails with pictures back and forth and felt better after words too. Thanks for the help!!