larsonta
New member
Mopar 4" lift on 2015' JKU by Jeep dealer uses stock rear drive-shaft and now having
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
Mopar 4" lift on 2015' JKU by Jeep dealer uses stock rear drive-shaft and now having
- Thread starter larsonta
- Start date
larsonta
New member
Issue is with that OEM rear drive shaft coming into contact with skid plates on BOTH the carbon vapor canister and the Fuel tank... the boot was damaged by the canister skid plate, and dealer said the drive shaft doesn't move. Well, I have pictures and video of the shaft coming into contact when either of the front tires are up as shown in the picture...
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
larsonta
New member
Why doesn't Mopar replace the rear shaft as part of the kit - like they do with the front shaft? ... or tell you about this problem if you leave the OEM shaft in place ? Any suggestions?
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
OverlanderJK
Resident Smartass
I've your evap canister over 2" and problem solved.
larsonta
New member
Ummm, I thought about that but then the fuel tank is still an issue...
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
aTX427
New member
Is the problem with the 2012-2017? I did not have a problem with my 2007 and it has 4" of lift. I'm also on stock length arms and the stock DS, along with a large HD canister skid.
larsonta
New member
Not sure about the extended bump stops ... anyone have a picture of what those look like installed?
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
larsonta
New member
larsonta
New member
There is still a few inches left to bottom, the tire is scrubbing the wheel well
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
BaddestCross
Active Member
Sounds like the rear track bar needs to be raised. Your axle is probably off center with that much lift.
Sent from my SM-N915P using WAYALIFE mobile app
Sent from my SM-N915P using WAYALIFE mobile app