Arb Air Locker Manifold. Where did you mount it?

[OscarMike2.0]

I currently have the Dual Arb Compressor and a sPod but now have no room to mount my air locker manifold. Before I take the time to extend the line and fab my own mount I wanted to see if anyone on here had come up with a solution that may be less time consuming.

 

[kpig]

Mounted mine to the firewall with two sheet metal screws. Sorry for the bad pic.

 

[OscarMike2.0]

Mounted mine to the firewall with two sheet metal screws. Sorry for the bad pic. View attachment 151870

No problem. Could you snap a few more pics of how you got the air locker solenoids to fit. Where is the chunk for airing up?

 

[kpig]

The manifold is mounted with the center can outlets pointed toward the front of the vehicle so the solenoid sits upright. The chuck for the air outlet is mounted on a plate between the compressor and the manifold. This is a bit different because the compressor started out as a portable unit in a case. I converted it when I swapped in the rear ProRock 60 with ARB. I will post a couple more pics in the morning.

 

[OscarMike2.0]

The manifold is mounted with the center can outlets pointed toward the front of the vehicle so the solenoid sits upright. The chuck for the air outlet is mounted on a plate between the compressor and the manifold. This is a bit different because the compressor started out as a portable unit in a case. I converted it when I swapped in the rear ProRock 60 with ARB. I will post a couple more pics in the morning.

Ok thanks!

 

[kpig]

Hope this helps.

 

[OscarMike2.0]

Hope this helps.
View attachment 152034
View attachment 152035

It does thanks! Im guessing you took the brackets off. Screwed them into the body and then reinstalled the manifold on the brackets?

 

[kpig]

It does thanks! Im guessing you took the brackets off. Screwed them into the body and then reinstalled the manifold on the brackets?

Yup, just measure carefully so the manifold reassembles without leaks afterward.

 

[FastZach]

Don't mean to resurrect an old thread but I am putting an ARB twin in my dads JKUR to fill tires and for an arb locker in the rear. How many ports does the ARB compressor has? Do I need the manifold kit in order to run the locker?

 

[cozdude]

Don't mean to resurrect an old thread but I am putting an ARB twin in my dads JKUR to fill tires and for an arb locker in the rear. How many ports does the ARB compressor has? Do I need the manifold kit in order to run the locker?

Yes you need the manifold to run the lockers.