Search results

Made some cardboard templates and cut up some steel i had on my makeshift bandsaw jig lol. As far as pics, I didn't take any after weld in and paint but its not much different than what I posted Sent from my SM-G973U using WAYALIFE mobile app

Here what I came up with. I could have added some gussets to it but I jacked the jeep up and the end of the rail next to the rear tire and it didn't bent at all. I think I'm gonna run with it for now. That being said I'm finally done lol Sent from my SM-G973U using WAYALIFE mobile app

You can see where the old tube went Sent from my SM-G973U using WAYALIFE mobile app

Some pics Sent from my SM-G973U using WAYALIFE mobile app

Hey guys, been a while since I posted on here but I figured that this was the spot for some evo info. Just installed a EVO high clearance long arm on my 2dr jk and i was wondering what grease i should use for all the johnny joints on the all of the arms. Tia Sent from my SM-G973U using...

This. Just did new spring perches on mine. Just take your time and make sure all is clean sent from a guy with a Jeep

No bumper here. Made some tabs for tow points to cover the holes and done. sent from a guy with a Jeep

not really what I wanted but they should make a good bushing or something sent from a guy with a Jeep

I use my 16' 1500. Trailer brakes, all oil coolers and a W.D. hitch sent from a guy with a Jeep

I was wondering why I kept eating axle shaft bearings after finally realizing that both passanger and driver side rear axle shaft flanges are bent. Right now I'm running nitro axle 35spline shafts and from what I read they don't warranty bent flanges, so it looks like I'm in the market for some...

Tapped it off with a srewdriver and a hammer sent from a guy with a Jeep

You can see how far the shaft walked out on me. This is the rotor rubbing the caliper bracket sent from a guy with a Jeep

You can see my 240v electric heater in the top of the photo. It does great for a non isulated concrete floor garage. In the dead of nj winter it makes it warm enough to wear a long sleeve shirt or sweatshirt and still be comfortable sent from a guy with a Jeep

And the inside Compared to the "used" one lol sent from a guy with a Jeep

Here's cancerous.... I found a used one on eBay for a decent price. Gotta search at junkyards to get one for a decent price sent from a guy with a Jeep

Armpit new jersey sent from a guy with a Jeep

Yeh I tried a couple things and ended up putting the tank back in as it was. Im going with your idea, should fix itself. I did get the new oem skid on after painting and cleaning the old mud and crap that was up there. sent from a guy with a Jeep

Anyone have any tricks for popping out a dent in the plastic gas tank without pulling the fuel pump and all? I'm loosing some capacity that I would like to get back. On to the rust porn sent from a guy with a Jeep

sent from a guy with a Jeep

Thanks rancho!.... Now I have a better spot than the floor for my beer when I'm wrenching sent from a guy with a Jeep