Search results

Since upgrading to 37s, at full stuff I have some rubbing in the rear. I was thinking about just trimming my bumper back as bit (around where the red line I drew is), and cut the corner of the pinch-seam off. I'm assuming this will be pretty trivial, but since this will be very visible and I...

I have a feeling this is a bad idea, but I was wondering if it would be possible to put a jack on my exhaust (at the lowest point shown in this photo) to slightly bend it so it's maybe 1/4" to 1/2" higher? It doesn't appear to be supported anywhere near there. Will it give/bend if pressed, or am...

I'm going have to leave my Jeep unused in my garage for about 3 months. What all should I do to prepare it? I was planning on putting Stabil in the fuel and running it through the system for a few miles, putting it on a battery tender, and probably jacking it off the ground just to make sure I...

I have a good amount of surface rust forming on my axle and some suspension components. I've done a bit a reading but am still not really sure what the best course of action is. I'm going to start by cleaning the surface a bit with flapper disk where possible, wipe it down and spray with...

I have small LED light on my spare, it's connected to an S-Pod that was installed by the previous owner. I was wondering if it would be possible to wire it up to function as a reverse/backup light as well? So it would come on when I hit the switch on the S-Pod or when I put my Jeep (manual, if...

I bought a set of tires through a local store part of a chain and mounted them on beadlocks. I didn't remember until I had a couple mounted that they're asymmetrical and had one backwards. The shop said they'd remove it for me (I had already set the bead). I just noticed a chunk (probably only...

I've been considering beadlocks and was surprised to see such a weight difference between these two: Machete Crawl KM22979050538N: ~45 lbs Grenade Crawl KM23579050538N: ~35 lbs Overall the appear very similar, and even have the same load rating, I was surprised to see that the Machete is nearly...

I have a 2015 JKUR with the Mopar Stage 3 lift kit and have been trying to improve my steering. After installing new ball joints, tie rod and drag link I got an alignment and found my caster was only 3.2 degrees. My lift kit doesn't have adjustable control arms, so I was considering replacing my...

I have a 2015 JKUR with the 3" MOPAR lift on 35s. It currently has about 35,000 miles, I've only put about 4,000 miles on it and the previous owner did most of the modifications shortly after buying it new. Since I've had it I've noticed a lot more play in the steering more recently. The...

I have a manual 2015 JKUR with the 3" Mopar lift, 295/70r18 (basically skinnier 35s) tires, stock 4.10 axles and I feel like I really have baby the clutch when starting from a stop compared to other stick shift vehicles I've owned. From the charts and posts I've seen, it sounds like 4.56 is...