Search results

Can anyone confirm if the attached TSB PDF is accurate, it says lower ball joins are now supposed to be 59 ft lbs plus advanced to the next cotter pin slot? It doesn't says aluminum or iron knuckles though is this for both? I have a clicking while turning, which I assume is this.

Hello, just watched Eddie's new Warn Zeon XD install video and had a question about trimming frame rails. It looks like in the video the Warn Zeon XD winch sat behind them, is the factory steel bumper / Warn winch plate the only one that allows this? A couple of years ago we installed a Warn...

I’ve got the American adventure labs inner fender liners front and rear as well as their fender chop LED lights. I’ve chopped the fronts and got the lights and liners on. For the rears I can’t decide if I want to just install the liners or split the fenders as well. The only downside is the...

Hello, I have a Rubicon without the rear tow hitch, if I swap to the rear bar with a hitch do you know if I'll have more or less clearance for my spare tire? There's a little piece of bent steel that sticks towards the spare on the current bar, curious if it's worse or better on the hitch version.

Hello. I have a Clayton 2.5” overland plus lift on my gladiator and I’m looking to add some 38x12.50r17 Nitto Ridge Grapplers tomorrow. I test fit one today and at full lock I’m about an inch from the lower control arm. The only other tight spot appears to be that dang passenger side safety...

Does anyone know of a good Hard Tonneau cover (tri fold maybe?) that will still work with a half rack for a tent? I need the hard cover now but dont want to have to rebuy something else later to work with a half rack as well. Was looking at the Weathertek aluminum folding hard cover. Thanks!

Hey guys. Started installing my Clayton 2.5” overland plus lift kit on my Rubicon Gladiator today. I finished the back half and I’ll do the front tomorrow, I measured out all 4 rear control arms per the documentation for the 2.5” lift but after I got it all back on the ground the pinion angle...

Hello, I'm going to be adding a 2.5" Clayton overland plus lift kit to my Rubicon Gladiator this weekend and I'm curious if you guys think I have a chance at fitting the 38" Nitto Ridge Grapplers. If I do rub does anyone know where the pain points would be? Front or rear? I'd rather chop...