Search results

Figured out the winch situation. I sold the old m8000 and picked up a warn 8274. It'll need a rebuild nut it's complete and had the ratcheting brake.

We had a pretty bad snow storm for this area which caused all packages to be delayed. Finally got the rest of my tabs for my limit straps and my transmission shifter

Got half the tabs I need for the limit straps, going to start on them soon. Picked up a new zeon 10 for my TJ and going to use my old m8000 as a place holder until I figure out what I want to do with it.

I bought a dana 60 for Baboozle last year for his Willie's project. It didn't work out for him and I bought the as soon as he offered it. I got it home. Took off the drums and brake assembly's. I was doing research on and couldn't find anything that matched. I measured the ring gear and...

Got a pair of limit straps in for the rear axle. 20" in length. I need a pair of 18" for the front, ruff stuff was out of stock so I'll probably order a pair from summit. Been focussing on my TJ lately. An upper control arm bracket broke off my front axle, both relays in my dual air...

Thank you! It'll be out there soon!

Thank you!

Thank you!

Welded the yoke together. Installed it on to my transfer case and put my transfer case back in after remembering I forgot a gasket. Installed the front drive shaft. Did an full extension test, the splines didn't move.

Got the yoke figured out. I made a nut to help press the new yoke inside the old machined yoke flange.

I knew the new yoke for the front drive shaft wasn't going to fit as is but I knew I could make it work with the stock flange and a half round yoke. I took the flange to work and cut it to size, turned the outer diameter concentric with the spline diameter and bored the inner diameter .002"...

Getting closer to hitting the trails. Got a new front drive shaft from Adam's

Making progress on the floor pans, learning how to shrink steel. Definitely a steap learning curve

Started welding in the floor pans

I finally remembered to make some reservoir spacers for my coilovers. I uses some scrap plastic we had laying around at work.

Thank you, there never seems to be enough space

Thank you. Definitely like seeing paint over than the rust🤣

I cut a roof and cut some new floor pans and tweaked the new and old ones for fit. The transmission dipstick needed a support since it's so long, about 4 feet long!

Thank you!

Finished and painted both sides of the firewall and started on the floor pans. The new pieces need a little tweaking on the fit.