Search results

From EVO MFG site. Clearance isn't the issue as the TB sits in front of it. Possible they just throw it in just because. I know with a 3.5-4 inch lift there is no way that thing has no wobble or geometry issues. / ___ Last edit on this post. I thought you had a flipped DL. What you can do, is...

Method 105's as well. 17x9. 3.5 BS Hard to get a pic on the Jeep that doesn't look like a black blob

Will work with stock bumper and a few aftermarket bumpers that have the clearance between the grill and bumper. Its your job to check! Comes loaded with 3 7' round Hellas and all of the mounting hardware. You do not need to cut your stock bumper to install this. All 3 lights are wired single...

This is what it looked like stock, does your look like this with the bracket holding the lines to the bottom of the tub? Do you have a lift?

Check it out. I got a box. Damn nice box too.

Found this is my phone. I must have been taking random pics :crazyeyes:

Here you go. No extra charge for the dirt, some of it came at my expense :D

I wasn't going to say shit :dont_tell: Check this out though. This is not the actual pic of the sway bar but just for reference. I need to dig through my old phone to find pics of when it was stock and starting to put the lift on but same point. The stock sway bar would only go this far and...

Low angle on a JKU

Aside from checking the air at the compressor and putting the no limits on, I am at a stand still waiting on more parts but I did manage to kill that huge fing plug. Pics, because it happened. ;) Ta DAAAAAA. Carefull because that red wire is constant hot. Ax me how I know :doh: Finally...

Up next is what the pin looks like with the actuator off. I didn't take a pic of it when it was dirty but once you pull the stock actuator off, clean out the gear case real good and put some fresh grease in it. The big circle with the grease around it is what moves the forks that unlock the...

Here is a quick shot of the compressor and the ARB solenoid with the ARB fitting installed. In answer to the question, how to hook everything up, I am going to run the sway bar disco off the solenoid in the picture. On the second port with the hex head plug in it I have a 2 port manifold on the...

Lets get this train back on track :thumb: For those of you that are saying "sell your motors" please understand this....... The entire gear case looking silver thing is not a motor, it is a set of gears that that get locked or unlocked by a pin, that is controlled by a actuator. Yes its a...

Google brought me here and Eddies help kept me here.

Will this work? Its a 37x13.5x17 and I think the OD is 36.7

Rather than start a new thread I am just going to add this here....... When you buy the kit, this is all that comes in the box. Aside from OBA, you will need to get a few things to get this this working. You can source the parts on your own like the air line and fitting to save a little bit...

I was suppose to get 20 feet of 5mm air line to connect the no limits up and ended up with this. F em, Im not sending it back >:(

its a purse holder for a trail hawk and im done :eek:

f those things. still have me searching like a crack head :crazyeyes: