Search results

Those V10’s pull very well. I had to add a backup camera to my 06 F250 with a camper just to see.

John Bull last Saturday

Yes, chunked on most of every tire but still have a little over 50% tread. Definitely will be saving for new tires. Thanks

Soon!

Hello I was washing my Jeep this weekend and spotted some cracks in the sidewalls. Are these anything to be concerned about? There’s more than these two. They were produced in 2018. Thanks

Yes

Will do, that was one of the items I was thinking. Usually run between 27-30 psi but I’m going to check. Thanks

1/8” and I’m running 37’s

Hello I’m running into a couple issues I could use a little help with. - I recently changed my TRE’s on my RK HD chromoly tie rod with the referenced one from Eddies write up but the driver side shaft protrudes passed the ideal height for the cotter pin through the castle nut. I did have to...

Ten factory rear axle shafts, no install pics because I was pressed for time but no more brake squeak.

Price reduction thanks

Price reduction thanks

Wasn’t to hard at all, just watch the angle of the pan while removing. I just use Walmart brand fluids on my Jeep, never had an issue.

Price reduction make an offer

Price reduction Will trade for body mounted tire carrier

I have a set of EVO 4” plush rides with Air rite airbags only used 2 trips. $225 for the coils without airbags OBO Evo Crossmember Skid used but functional $90 OBO Thanks located in Fontana, CA

I’m going to see if I have clearance for this setup. Thanks

Mine are exactly the same position but I have schraider valves on the reservoirs that I’m worried about being ripped off.

I just installed my new to me Fox 2.0 with reservoirs on my Jeep and noticed that the reservoirs are in harms way. Where’s everyone mounting there’s? I googled and searched and seen someone that mounted them on the rear sway bar but it didn’t seem right. Thanks

This waterless wash works pretty good. I use it on mine when I don’t have the time for a full wash and provides a nice shine.