Search results

When I had my hard top it wasn't to difficult to get in the tub and get the extinguisher when needed but with the Trex Top NX it is a little more work and might render it un usable - I would prefer to have one up front or at least reachable from the drivers seat but having a hard time finding a...

I know my Jeep will never be in the "Bad Ass" category but I am one step closer! :rock:

Weather Forecast just keeps getting better! :thumb:

One small tip on the plastic trim: When you cut the plastic you have to (well at least I did) cut the white plastic push pin and its mount off which leaves the back end a little loose in my opinion. What I did was took the push pin and just glued to the molding piece and it is long enough to...

#ff

This is not for everyone but how I did it Whats required is here: http://wayalife.com/showthread.php?17832-The-quot-Mid-Life-quot-buy-thread&p=389948&viewfull=1#post389948

Finished up the trim job on my A-Pilar plastic. This is a lot of work just to make it look nice. There is a lot more trimming involved then I thought. I don't have a Dremel or Coping saw so I did the entire Job with my pocket knife! I know "I might be a red-neck". The hardest part with the...

Swapped out my CB for a Cobra 75 and switched antennas to a Wilson 2000. Seems to work really well and saved me tons of precious headroom! :beer:

To sweeten the deal I will also throw in a 5" PA Speaker horn for FREE!

..........

Check to make sure you have a good ground - both at the antenna and the radio itself

I think Ridge had one of the funniest memes here so I had to add to it.

I am selling my Cobra 29 LX LCD CB Radio it is 7 months old and works perfectly. How much you ask? Asking $80.00 o.b.o. and I will throw in a Valco EZ CB mount for FREE and to keep this savings bonanza rolling I will also throw in a Strike force Zebra mount in case you prefer a smaller...

..........

Quartzsite AZ a few more photos here: http://wayalife.com/showthread.php?24462-Quartzsite-Parker-AZ-2-15-16-2015

Ran out to Quartzsite AZ this weekend to do a little wheeling with may Dad and his group. Sunday we ran up to parker to take some visitors to the Desert Bar. We go in the back way which is a fun trail and usually leave the trail and take the wash most of the way. We did parts of Presidents...

Got the center bar in today along with the tire carrier bar after painting. I will tell you this project was a comedy of errors :cheesy: First off I decide to rattle can it just to save some coin, Not checking the weather first, Santa Ana winds gusting to 40 flare up while it is drying so I...

Made a little progress on the cage today, Drilling and grinding is always fun - but things went downhill after this. Here is a pic no one wants to see :doh: Template was aligned correctly - plenty of clearance on the side piece but the backing plate was at a angle so 2 holes did not line...

Crappy picture but it is so nice here in social - I stripped down a day early :rock:

Cleaned and Primed - will paint tomorrow and install on Thursday. Funny thing - I forgot I haven't painted my rear harness bar yet and realized it after I cleaned up :doh: oh well will pull it and paint tomorrow. Note: good old all american brake cleaner made short work of the residue :thumb: