Search results

Can someone with the evo body mount tire rack measure from the tailgate (next to handle) to the outer tubing? Need to see if it’ll work with my garage situation. I currently have to touch the spare to the work bench against rear wall and I have 1.5” clearance to garage door. Sent from my...

I've narrowed down my rear squeak to what I think are the rear brakes. Dynatrac progrip. I have speed bumps in my new neighborhood, so I've had time to try this out. The rear has a loud squeak from both sides on the rear axle when hitting an abrupt bump (speed bump). If I drag the brakes...

Prepping for Moab and trying to figure the best way to carry a couple gallons of antifreeze, a few quarts of engine oil, steering fluid, and gear lube. I bought one of those black boxes with the yellow lids, but it's a little too short for the gallon bottles so they have to lay on their side...

After 6 months of researching, I pulled the trigger on the PSC hydraulic ram steering for my 2015 wrangler. Here are some pics and my install notes. I had an EVO drag link flip, and learned that the bracket won't work with the steering ram, so it was removed it. I had the stock track bar...

Well now that I'm officially transplanted to Ft. Lauderdale/Miami and found a jeep club, it looks like I need to prep for bottomless mud and deep, deep water. I've already extended my axle breathers, but they said I need to to the trans and x-fer case, and not only extend them, but put a couple...

In preparation for the PSC steering system install I was researching pitman arm pullers and reading about the difficulties in removing the arm. A new crown pitman arm is $31.99. Would it be better to just buy a new arm for the box?

I'm stuck between the Currie and EVO front lower arms. I like that the Evo's can be adjusted on the jeep, but I'm not sure how they hold their adjusted length? Is the inside of the control arm smooth, and clamps to the threaded johnny joint? That seems like it could slip. The currie is a...

Anyone know? I didn't measure mine before swapping and my garage door is pretty darn close to the hard top. Because I'm in Miami now, the hurricane proof garage door has menacing floor anchors that stick down, and the floor slab is raised for water proof-ness. I did get the upper limit switch...

I want to install before I go to Moab this October. I have a lot of steering feedback on the highway and in the rocks I can't move shit. Preferred vendor? What do I want to run for an evo drag link flip and also the Currie correctlync tie rod (the $335 one, not the $700 monster)?

430n Navigation head unit 2015 RHB model- $550 shipped Sold Like new nav head unit from my 2015 rubicon. They go for $800 on eBay, but I'm only asking $550 because I don't have the unlock code. It might be needed when powering on and if it is, you either have to see the dealer to get it...

In prep for my 5000 miles of highway to do Moab, I'm thinking about mastercraft rubicon front seats. But my jeep is a daily driver. Questions: Will I retain my height adjuster? How is under clearance? I have a bestop safe under driver and a arb twin compressor under the passenger I don't...

My jeep group is heading to Moab in October. I'll be in Miami at that point. It's 2500 miles each way. I'm wondering if there any options to rent a truck and trailer that won't cost me $4000k (Penske, Ryder, Uhaul all charge by the mile, or $2k each way for a one way move). Or am I stuck...

My Pioneer 8200 NEX head unit can take a second camera input, I'm interested in running a front "spotter" cam. Why? Well why not? We run with spotters, but sometimes it would be nice to actually see what the front tires are doing. Has anyone done this? Is it worthwhile? Where do you mount...

I know, what's wrong with me? I sold my AEV wheels with 315 duratracs to my sister for her jk. I'm now running 37x13.5 Cooper SST Pros on Chamber Pro 2 beadlocks. While they're going to handle my off-road duties for the next couple of months, I'm re-locating to Miami in August for 2-3 years...

So not too long after my re-gear, my rear right axle seal went out. Granted I've been through many water/mud pits, and my shops says that's the culprit. So last week he pull the shaft and we replaced the seal, bearing, and "wedding ring" and de-greased the brakes and put new e-brake shoes in...

Passed you going on base today, just wanted to see what member it was.

A few of us Virginia folks hit up chaos off-road park in West Virginia yesterday. It was raining for 3 days prior so pretty slippery. It's fun to see how a double throw down 40" jeep and a rock bounder buggy handle the terrain too. Sorry, no music and I did all the filming so not much of my...

My tie rod is frowning after off-roading a rock garden. What tie rod to I want for a stock rubicon axle? Sent from my iPhone using WAYALIFE mobile app Edit- never mind, went with the $350 correctlync instead of the $700+ monster one. 200% stronger than stock should work for me.

After having a YJ on our last outing blow a rear driveshaft and watching the owner replace it with a spare, even drilling out the broken bolt and using an ez-out to remove it, I was blown away. Now I want to have a kick ass spare parts and tool kit that will only ride in the back when I'm on...

Evo drag link flip and 6" Evo end links. On the first damn trail today, there's a section that max flexes the suspension both ways very fast. Well coming down the trail the front end is clunking and I can barely steer. Turns out the drivers side sway bar flipped and the end link was jammed...