Search results

Just got the axle back thanks to a quick turnaround by Barry at the Rear End Shop here in Livermore. :thumbup: Figured while everything was apart I would wire wheel some of the surface rust on the knuckles and give them a fresh coat of paint.

And it's outta here! :thumbup: Off to the gear shop for the swap!

Brakes, unit bearings and axles out. Next up is hammering the knuckles off. Hoping to keep the tie rod and drag link connected.

And we're off!

Now onto Saturday for our adventure to Saddle Lake. Heading South around Long Lake Brian doing some work in Jen's Jeep Scott preparing for launch Panda pointing skyward! Morris Lake Back at Campbell Lake Leaving the trail headed home Group shot! Awesome time everyone...

Just got home and cleaned up. Such an amazing trip with awesome friends! A huge thanks to Jen and Jason for helping organize the run! :thumbup: Now for a few pictures. ;) Working our way down to Morris Lake Climbing out Back on top Back at Campbell Lake, our campgrounds for...

Brown Santa was nice nice to me today! Install starts next week! :thumbup:

All packed and should be rolling out soon!

Here are the best pictures I have at the moment: I have tried installing the FireRing using the two different orientations outlined by FireStick, but neither seem to make a difference. The paint under the ring has been removed and was cleaned down to bare metal. Thanks again guys for all...

Around the beginning of the year, I installed a new Cobra 75 along with a Fire Ring coax and 3' FireStik. The antenna was installed on the top of my AEV tire carrier mast. At the time of the install, the lowest I could get my SWRs was in the low to mid 2s. After quite a bit of troubleshooting...

Count me in! Thanks for the opportunity! :thumbup:

Excellent job Eddie and Cindy!! The video came out great. Can't wait to watch it again! :thumbup:

Looks like we are going to have perfect weather next week! :thumbup:

Sure! I'm sure everyone will arrive to some professionally erected tents! :cheesy::cheesy:

More famous Lincoln quote: :cheesy:

And on a completely different note, we put the finishing touches on the house and it is officially done! :) Here is the newly finished kitchen: And one more HUGE THANK YOU to Rob, Ken and Russell for their help along the way! Couldn't have done it without you guys! :thumb:

Just pulled the trigger on one of these: :D:D:D:D Also picked up a set of RCVs and Dynatrac ProSteers to go with it! Woo hoo! With any luck the pallet will be here mid-next week.

Hoping to pull the trigger next week on a PR44 and was curious what the optimum caster is with the 10° housing. I'm currently running the stock 4.2° of caster and have heard the extra caster in the Dynatrac axle adds a nice level of stability. Driveline vibes aside, what caster angle is a good...

Just wanted to put a feeler out there as I am itching to pull the trigger on a front axle swap. :) I would be swapping my carrier and gears into a ProRock44 along with all the outer hardware with the exception on the Dynatrac ball joints. In addition to the ball joints, the axle has a few...

Tie Rod Recommendations? I've been noticing a bit of slop in my steering recently and today while under the Jeep I took a pair of channel locks to the TREs on both ends of the Tie Rod and Drag link. The ends on the drag link were solid, however, the driver's side TRE on the tie rod had quite a...