I went route of weight distribution hitch , which has worked great. Have taken on highways, local and gravel . No issues thus far.
Sent from my iPhone using WAYALIFE mobile app
Used quadratec JT fender kit. Mounted antenna on driver side
Handy mounting bracket available to leverage just inside to hold coax cable
Ran along wiring , installed coax installation per instructions and pulled up under drivers side front seat.
Ran under plastic door guard, under...
Started during lunch to run wiring for power. Goal is to run coax on driver and the power on passenger. Attached is the power side.
I took off the right side panel with T40 torx.
Then inserted hanger from outside hinge. Under rubber cover.
Then taped power wires and pulled back through...
Installed afe momentum air intake system. Instructions are detailed and straightforward. Took about 30 minutes. Immediately changed the power but with no significance. The sound of air being pulled into engine is noticeable and sounds great. Won’t be able to hide the change from spouses or...
Quick-update:
Took time to install VR12s this week. Used Warn mounting bracket. As highlighted by others , you will need to drill out lower number skid mounts to get factory bolts back in place. Overall delighted with ease of install. Factory 55 flatlink should be arriving today. That will wrap...
Had purchased a few weeks ago but hadn’t taken the 3 min to replace. 4 -10mm bolts later replaced. I was amazed at the difference in thickness and girth! Can’t wait to get on the trail! Great first impression.
Sent from my iPhone using WAYALIFE mobile app
Ran 16gauge (overkill) through sleeving from battery (where aux wires can be found) back to rear. Sleeving was a pain but outcome looks great. Was able to chase existing lines most of the way for a pretty tight run.-
Sent from my iPhone using WAYALIFE mobile app
After adding the BuiltRight side storage, the standard bed lighting was no longer effective. Also have lighting that could be redirected to the tailgate as well as behind the rig would be nice. I decide to use Rigid backup lights and some generic GoPro rotating arms for the install. Mounting the...